2 
Installation and Setup
General Information
This section will guide you through the installation and setup of your P330i or P330m Card Printer. This consists of the following procedures, which should be performed in the order presented.
•Unpacking the Printer
•Installing the Print Driver Software and Setting Driver Options
•Loading a Ribbon
•Installing the Card Cleaning Cartridge
•Setting the Card Thickness Control
•Loading Cards
•Connecting the Printer to your Computer
•Connecting Power
•Printing a Test Card to verify printer operation
The procedure to be followed for Packing the Printer for Shipment is given at the end of this section.
The printer should be placed in a location that allows easy access to all sides. The printer should never be operated while resting on its side or upside down.
Electric Shock Caution • Limit AC power supplied to the printer to 110 ~ 230 volts, 60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated circuit breaker or other such device. Never operate the printer in a location where operator, computer, or printer can get wet. Personal injury could result. The printer must be connected to an earthed electrical power source and properly protected against electrical surges and grounding faults; the electrical reliability of the printer is based on the reliability of the mains power source and with the earth connection.
The printer’s power supply is an internal unit that can only be serviced or replaced by trained and authorized personnel.
P330i & P330m Card Printer User’s Manual | 5 |