Zebra Technologies Desktop Printer manual Attaching Power Supply

Page 16

Attaching Power Supply

Check the power supply to make certain it is appropriate for your input voltage.

Warning: Use the power supply that came with your printer.

Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!

1.Make sure the power switch is in the off position (down).

2.The DC power supply has a barrel connector on one end that must be inserted into the power supply receptacle on the back of the printer.

3.Insert the separate AC power cord into the power supply.

4.Plug the other end of the cord into an appropriate AC electrical outlet.

Plug

Varies by

Country

Barrel	AC
Barrel	Power
Connector	Cord

Power

Switch

Power

Supply

Power

Supply

Receptacle

8	980483-001A

Image 16

Contents Zebra LP 2844 TM 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Introduction HelloWhats in the Box? Inspecting the Printer Opening the printerInspecting the Printer Closing the printer Related Documentation Reporting DamageGetting Started Modes of PrintingAttaching Power Supply Loading Roll Media Placing the Roll in the Media CompartmentAdjusting the Guides Power Switch Operator ControlsFeed Button Status LightMedia Length Sensing Hooking Up the Printer and Computer Interface Cable RequirementsUSB Interface Requirements Parallel Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsCommunicating with the Printer Universal Serial Bus USB CommunicationsParallel Communications Internal ZebraNet PrintServer II CommunicationsCommand Serial CommunicationsAdjusting the Print Width Adjusting the Print Quality980483-001A Operation & Options Thermal PrintingReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Maintenance CleaningPrint Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Lubrication Platen ConsiderationsReplacing the Platen AssemblyRemoval Replacing the Print Head Direct-Thermal LP Model RemovalAssembly 980483-001A Troubleshooting What the Status Light is Telling YouPrinter Operation Media Handling Print Quality Problems Print head is under temperatureNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Resetting the Factory Default Values Communications DiagnosticsFeed Button Modes Printer Condition Feed Button ActionAppendix Universal Serial Bus USB ConnectorInterfaces Parallel Interface HostLooking into the Printer’s RJ-45 Modular Connector ZebraNet PrintServer II Internal Ethernet PrintServerSerial RS-232 Connector