Zebra Technologies Desktop Printer manual Direct-Thermal LP Model, Removal

Page 38

Direct-Thermal LP Model

MOVIE

Before following the steps in this procedure, open the printer by pulling the release latches forward then lifting the top cover.

Removal

1. Use a #1 Phillips driver to loosen the four screws that hold the latch frame to the top case.

2. Grasp the print head spring and pull it

to the left; then, slide it free of the latch frame.

3.	Gently pull the wire bundles from the
	print head.
4.	Use a #1 Phillips driver to loosen the
	two screws and washers and release
	the print head from the latch frame
	and bracket.
30	980483-001A

Image 38

Contents Zebra LP 2844 TM 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Introduction HelloWhats in the Box? Inspecting the Printer Opening the printerInspecting the Printer Closing the printer Related Documentation Reporting DamageGetting Started Modes of PrintingAttaching Power Supply Loading Roll Media Placing the Roll in the Media CompartmentAdjusting the Guides Feed Button Power SwitchOperator Controls Status LightMedia Length Sensing Hooking Up the Printer and Computer Interface Cable RequirementsEthernet Interface Requirements USB Interface RequirementsParallel Interface Requirements Serial Interface RequirementsParallel Communications Communicating with the PrinterUniversal Serial Bus USB Communications Internal ZebraNet PrintServer II CommunicationsCommand Serial CommunicationsAdjusting the Print Width Adjusting the Print Quality980483-001A Operation & Options Thermal PrintingReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Maintenance CleaningMedia Path Considerations Cleaning Card ConsiderationsPrint Head Considerations Lubrication Platen ConsiderationsRemoval AssemblyReplacing the Platen Replacing the Print Head Direct-Thermal LP Model RemovalAssembly 980483-001A Troubleshooting What the Status Light is Telling YouPrinter Operation Media Handling No print on the label Print Quality ProblemsPrint head is under temperature Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Resetting the Factory Default Values Communications DiagnosticsFeed Button Modes Printer Condition Feed Button ActionInterfaces Universal Serial Bus USB ConnectorAppendix Parallel Interface HostLooking into the Printer’s RJ-45 Modular Connector ZebraNet PrintServer II Internal Ethernet PrintServerSerial RS-232 Connector