Appendix A Replacing hardware 47
4Slide the power supply module or dummy power supply filler pack out of the slot.
5Insert the new power supply module or dummy power supply filler pack into the empty power supply slot.
6Using a screw driver, tighten the four securing screws on the sides the power supply module. Verify that the securing screws cannot be loosened by hand.
7For each power supply module, set the power supply breakers to on.
8If you inserted a new power supply module, confirm that the power supply LED is to off.
If you inserted a dummy power supply filler pack, contact FLS immediately to order a new power supply module.
Replacing a board module
The Passport 8250 is equipped with 4 board slots, one slot for the network board and 3 slots for the service boards. See “Board slots” (page 48) for an illustration of the slots. If the Passport 8250 device has less than three service boards, dummy circuit card filler packs are needed for the empty board slots.
Passport 8250 Installation Guide R2.2