Installation
Connecting the Hub Through the MDI Port
You can connect BayStack
To connect to another device through the MDI port:
1.Insert an
You can configure port 1 to uplink or normal mode using the
2.Set the
3.Insert the other
You can also connect this
Applying Power to the Hub
To apply power to your hubs:
1.Plug the power cord into the power socket in the rear of the hub.
2.Plug the other end of the power cord into a standard power outlet.
The hub will automatically select the setting that matches the connected input voltage. No additional adjustments are necessary when you connect the hub to any input voltage, as long as the voltage range is within the range marked on the rear panel.
3.Check the Power LED on the front panel.
The Power LED should be on. The hub will perform a
Note: The hub supports a “hot remove” feature which permits you to connect or disconnect cables without powering off the hub. Operation of devices attached to the hub is not disrupted.