The LK (Link) LED for each port being connected with a remote modem will illuminate solid or flashing green to indicate a connection has been established. Link up time between interface modules and remote modems can vary from one to five minutes depending on the quality, gauge and distance of the copper cable pair(s) being used. Refer to individual interface module user guides for specific information such as connector pinouts, parameter configurations and distance capabilities.
ADSL2+ INVERSE MULTIPLEXER | PWR | RX TX LK 1 2 3 4 5 6 7 |
|
|
Securing the Connecting Cables
Position all connecting cables such that they will not become a tripping hazard or pull loose from the chassis; secure with cable ties or
Configuration and Management
Although no configuration is necessary to run subscriber lines at the default settings, all 4000E parameter settings are software selectable via Command Line Interface (CLI), Simple Network Management Protocol (SNMP), and/or the Network Management System (NMS). 4000E management capabilities depend upon the management module model installed in your chassis. Once the management module has been initialized, the interface modules installed in your 4000E may also be configured as desired. Refer to the following for further information:
Table 1: | User Documentation | ||
|
|
| |
Document |
| Contents | |
|
|
| |
Management module | z | module installation | |
installation instructions |
| port pinouts | |
| parameter defaults | ||
| parameter configuration options | ||
|
|
| |
|
|
| management system capabilities |
|
|
| |
Uplink module | z | module installation | |
installation instructions |
| port pinouts | |
| parameter defaults | ||
| parameter configuration options | ||
|
|
| |
|
|
|
|
16 | 4000E IP Broadband Loop Carrier Installation Instructions |