Nortel Networks NN44470-100 manual Users properties

- 56 -

Nortel MAS Console

Field	Description
Supported Digital Relay	You can enable or disable the following supported
Methods	digital relay methods: INFO Digits and RFC2833.
	Attention: Nortel recommends that you do not
	disable all methods. If you disable all methods,
	inband DTMF detection is enforced and system
	capacity degrades.
Add	Click Add to enable a digital relay method. From
	the Available list, select a digital relay method, and
	then click Add.
Add All	Click Add All to enable all digital relay methods.
	From the Available list, select a digital relay
	method, and then click Add All.
Remove	Click Remove to disable a digital relay method.
	From the Enable list, select a digital relay method,
	and then click Remove.
Remove All	Click Remove All to disable all digital relay
	methods. From the Enable list, select a digital relay
	method, and then click Remove All.
Up and Down	Use the Up and Down buttons to change the order
	of the enabled digital relay methods.
Assign RFC 2833 Payload	This check box is selected by default. Nortel
Type Dynamically	recommends that RFC 2833 payload type is
	assigned dynamically. However, some clients
	require a fixed payload type.
Specify Type	If you require a fixed payload type, clear the Assign
	RFC 2833 Payload Type Dynamically check box,
	and then in the Specify Type box, type the payload
	type.
Restart Required	This is a read-only field. It indicates whether a
	restart of the server is required if you modify the
	trusted node host name or IP address. Values are
	Yes and No. Yes indicates a platform restart is
	required for the configuration change to take effect.
OK	Click OK to close the dialog box.
Cancel	Click Cancel to close the dialog box without saving
	changes.

Users properties

The following figure shows an example of a Users Properties dialog box.

Nortel Media Application Server 6.0 for AS 5300

Fundamentals

NN44470-100 01.01 Standard

Release 6.0 03 June 2008

Copyright © 2008, Nortel Networks