Tektronix 200E, 200I instruction sheet Install Board Install ribbon cable

Page 7

Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ 240

4.Connect the I/O boardÕs ribbon cable to the image processor boardÕs I/O connector. Tilt the I/O board forward into place against the rear of the printerÕs card cage. Secure the I/O board in place with the two thumbscrews.

Install￿

I/O board

Install￿ ribbon cable

31865-06

5.Reconnect the interface cables. Turn on the printer and examine the startup page it should automatically print out. Refer to the Phaser 240 Color Printer User Manual for details on connecting interface cables and making prints.

7

Image 7
Contents Static electricity precautions Kit contentsRemoving the old boards Remove screws Lift out the engine control board Simm installation on the new image processor board New image processor install Install Board Install ribbon cable Return the old boards to Tektronix