Primera Technology 74293R, AP360, AP362 quick start Loading the Label Stock

Page 4

Section 2: Loading the Label Stock

1.Remove the Roll Bar and Roll Guides from the Label Applicator. The Roll Guides and Roll Drag Arm are removable and adjustable. They are held in place magnetically. (Figure 2-1.)

Figure 2-1.

2.Remove one Roll Guide and the Roll Drag Arm from the Roll Bar.

3.Place the label stock roll on the Roll Bar with one side against the upright of the remaining Roll Guide. Place it on the Roll Bar with the loose end of the stock feeding underneath the roll. (Figure 2-2.)

Figure 2-2.

Tip! For smaller diameter label roll cores you may need to reverse the Roll Guides so that the bottom of the guides are facing out to allow the uprights to be placed next to the roll.

4 AP360/362 Label Applicator

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Quick Start General Safety Information Unpacking and Setup Loading the Label Stock AP360/362 Label Applicator Tip! See for a Label Path diagram Tip! There must be no labels wrapped around the Peel Edge Labels are now ready for application Loading the Container 10 AP360/362 Label Applicator AP360/362 Label Applicator Apply the Label Applying the LabelApply two labels to the same container AP362 only Circumference width of front label width of back label Calculate distances for two-label modeCount labels AP362 Only Set the Mode of Container Roller Motor Run After Apply DefaultChange the Unit of Measure between Metric and English English InchesLabel Path Diagram Label Path DiagramTroubleshooting and Maintenance Unclamp Liner Idler Roller Clean Label Gap Sensor FlagLubricate bearings Specifications AP360/362 Label Applicator 511218
Top Page Image Contents