Primera Technology AP362, AP360, 74293R quick start Labels are now ready for application

11.If necessary, adjust the position of the liner on the Peel Edge left/right to align the liner with the label stock roll. Also, adjust the Label Sensor using the Label Sensor Bracket so that the Label Sensor Flag is roughly centered on the label stock. (Figure 2-9.)

Figure 2-9.

12.Push the Liner Idler Roller into the clamped position. (Figure 2-10.)

Figure 2-10.

Clamped Position

Unclamped Position

13. The labels are now ready for application.

Note: Position the Label Applicator on the edge of a table so that the liner falls to the floor. This will prevent excess labels from interfering with label applications.

8 AP360/362 Label Applicator