Primera Technology AP360, 74293R, AP362 quick start Tip! See for a Label Path diagram

Page 6

6.Now position the stock to correspond with the general area where it will be applied to the container.

7.Pull the loose end of the label stock forward and then push it into the Feed Area from the back of the label applicator. The labels will come out just underneath the Peel Edge. (Figure 2-5.)

Figure 2-5.

Tip! See Section 5 for a Label Path diagram.

8.Pull approximately 12 inches of label stock out beyond the Peel Edge. (Figure 2-6.)

Figure 2-6.

6 AP360/362 Label Applicator

Image 6

Contents Quick Start General Safety Information Unpacking and Setup Loading the Label Stock AP360/362 Label Applicator Tip! See for a Label Path diagram Tip! There must be no labels wrapped around the Peel Edge Labels are now ready for application Loading the Container 10 AP360/362 Label Applicator AP360/362 Label Applicator Applying the Label Apply the LabelApply two labels to the same container AP362 only Calculate distances for two-label mode Circumference width of front label width of back labelCount labels AP362 Only Change the Unit of Measure between Metric and English Set the Mode of Container Roller MotorRun After Apply Default English InchesLabel Path Diagram Label Path DiagramTroubleshooting and Maintenance Clean Label Gap Sensor Flag Unclamp Liner Idler RollerLubricate bearings Specifications AP360/362 Label Applicator 511218