Primera Technology AP362, 74293R quick start AP360/362 Label Applicator

4.Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either side of the Roll Bar but the rounded tip of the Roll Drag Arm should be located in the center of the inside of the core. The arm is spring loaded so that there is downward pressure on the inside of the roll. This helps prevent application alignment problems near the end of a roll.

(Figure 2-3.)

Figure 2-3.

5.Place the removed Roll Guide back on the Roll Bar and slide it close to, but not touching the label stock roll. (Figure 2-4.)

Figure 2-4.

Tip! Roll Guide Uprights must not pinch the label stock roll. (The label stock roll must have free-play between guides.)

AP360/362 Label Applicator 5