SATO CX200 manual PN9001050 Rev. B

Page 2

SATO America, Inc.

10350-A Nations Ford Rd.

Charlotte, NC 28273

Main Phone: (704) 644-1650

TechnicalSupport Hot Line: (704) 644-1660

Fax: (704) 644-1661

http://www.satoamerica.com

© Copyright 1998

SATO America, Inc.

Warning: This equipment has been tested and found to comply with the lim- its for a Class B computing device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed in accordance with the instruction may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interference to to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet or a circuit different from that to which the receiver is connected.

Consult an experienced radio/TV technician for help.

Caution: The FCC warns the users that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

All rights reserved. No part of this document may be reproduced or issued to third parties in any form whatsoever without the express permission of SATO America, Inc. The material in this document is provided for general information and is subject to change without notice. SATO America, Inc. as- sumes no responsibility for any errors that might appear.

PN9001050 Rev. B

Image 2
Contents CX200 PN9001050 Rev. B Page Sato America, Inc Nations Ford Rd Charlotte, NC Table of Contents CX200 Users GuideCX200 Users Guide What You Get Controls, Indicators, and Connections Printer Power ConnectionAccess Slots Loading Labels or Tags SetupPrinter Interface Connection CX200 Users Guide Loading Ribbon Take-up Core Sensor Calibration Selecting the Label Sensor TypeUsing the Printer Controlling the Printer Using Direct Commands Printing LabelsRoutine Maintenance Ready light is not lit Common Problems And Their SolutionsWhat To Do If Ready light glows redHost stops responding or displays printer not ready message Self-test label will not printLabels will not feed Poor print quality Technical SupportLabels feed continuously Printer Specifications Bar codesCommunication Ports Serial Input Connector DB9SParallel Input Connector Centronics 36 pin Standard Printer CablesCX200 Software Label Wizard CXMedia and Supplies Windows Driver
Related manuals
Manual 55 pages 28.53 Kb