SATO CX200 manual Controls, Indicators, and Connections, Printer Power Connection

CX200 User's Guide

Controls, Indicators, and Connections

Device Name	Primary Function	Use
		PRESS - to advance media
		PRESS while pressing READY
FEED Button	Advances print media	indicator - to print test label
		PRESS - to pause printing during
		batch mode operation
	Shows printer status	GREEN - Printer ready for data
READY Indicator		OFF - Printer busy, or Off-Line
	Places printer in On-Line	RED - Printer needs attention
ON-OFF Button		PRESS to switch to/from
	or Off-Line mode
		Off-Line or to reset the printer
Power Input	Connects to power supply	Connect to transformer provided
		with printer
		DB9 female connector for
Serial Port	Data input	connection to host controller,
		RS232 interface
Parallel Port	Data input	Centronics compatible connector
		for connection to host controller
Print Head	Unlocks print head	Push both releases toward rear
Release		of printer to release print head
Top Cover	Protects print media and	Lift to open
	mechanism	Push outward at hinge to remove

Printer Power Connection

1.Plug the output of the AC power supply provided with the printer into the connec- tor on the bottom panel.

2.Connect the supply into an AC outlet having the proper voltage.

Note:

CX200 printers consume very little power when idle, so are not equipped with a power switch. Pressing the READY indicator/ON-OFF (a com- bined control) will reset the printer and switch it from Off-Line to On-Line mode.

Important!

The required AC voltage is marked on the power supply. Confirm that your AC voltage matches the power supply requirements. Do not use any power supply other than the one provided with the printer.

Page 2 PN 9001050 Rev. B