Nortel Networks 2750 manual Figures

		11
Figures
Figure 1	Front view of the Nortel VPN Router 2750	26
Figure 2	Placement of rubber feet on the bottom of the chassis	29
Figure 3	Attaching the cage nuts to the rack	31
Figure 4	Installing the shelf in the equipment rack	31
Figure 5	Removing the front bezel	32
Figure 6	Replacing the front bezel	33
Figure 7	Rear view of the Nortel VPN Router 2750	37
Figure 8	Front panel LEDs	40
Figure 9	LEDs on the system 10/100BASE-TX Ethernet ports	41
Figure 10	LEDs on the 10/100BASE-TX Ethernet interface card	42
Figure 11	LEDs on the 1000 GT Ethernet interface card	43
Figure 12	LEDs on the 1000BASE-T (1000 MT) Ethernet interface card	44
Figure 13	LED on the 1000BASE-SX Ethernet interface card	44
Figure 14	LEDs on the 56/64K CSU/DSU WAN interface card	46
Figure 15	LEDs on the ADSL WAN interface card	47
Figure 16	LEDs on the T1/E1 CSU/DSU WAN interface card	48
Figure 17	LEDs on the quad T1/E1 CSU/DSU WAN interface card	49
Figure 18	LEDs on the single V.35/X.21 WAN interface card	50
Figure 19	LEDs on the SSL VPN Module 1000	51
Figure 20	Removing the front bezel	63
Figure 21	Removing the top cover	65
Figure 22	Location of option card and DIMM slots on the system board	66
Figure 23	Location of the grounding jack for the antistatic wrist strap	67
Figure 24	Installing and removing an option card	71
Figure 25	Replacing the front bezel	72
Figure 26	Installing and removing a DIMM	74
Figure 27	10/100BASE-TX Ethernet connector	79
Figure 28	Serial cable (9-pinD-sub plug to RS-232-C modem plug)	80
Figure 29	Modem cable (9-pinD-sub plug to RS-232-C modem plug)	81
	Nortel VPN Router Installation — VPN Router 2750