Nortel Networks 302403-G manual Shows the front panel of the BPS2000-4FX MDA

Page 16

Table 6 describes the 400-4FX MDA and the 8100-4FX MDA front-panel components.

Table 6 400-4FX MDA / 8100-4FX MDA description

Item Label Description

1

Link

Communications link LEDs (green):

On: Valid communications link.

Off: Invalid communications link or no connection to this port.

Blinking: The corresponding port is management disabled.

2

F Dx

Full-duplex port status LEDs (green):

On: The corresponding port is in full-duplex mode.

Off: The corresponding port is in half-duplex mode.

3

Activity Port activity LEDs (green):

Blinking: Indicates the network activity level for the corresponding port. A high level of network activity can cause LEDs to appear to be on continuously.

4100BASE-FX port connectors:

Models 400-4FX and 8100-4FX use MT-RJ connectors.

Figure 6 shows the front panel of the BPS2000-4FX MDA.

14

Image 16
Contents Installing Media Dependent Adapters MDAs Copyright 2001 Nortel Networks Product Safety Fibre optique sont raccordés à une source lumineuse Introduction Supported interfaces and products MDA descriptions10BASE-T/100BASE-TX MDAs 400-4TX MDA Item Label Description Shows the front panel of the BPS2000-4TX MDA 100BASE-FX MDAs 400-2FX MDA Shows the front panel of the dual-port BPS2000-2FX MDA BPS2000-2FX MDA 400-4FX MDA Shows the front panel of the BPS2000-4FX MDA Describes the BPS2000-4FX MDA front-panel components 1000BASE-X MDAs 450-1SR MDA Port redundant 450-1SR / 450-1SX MDA description Shows the 450-1LR MDA and the 450-1LX MDA front panels 450-1LR MDA Port redundant 450-1LR and 450-1LX MDA description Gbic MDA 450-1GBIC MDA Installing an MDA Describes the 450-1GBIC MDA front-panel componentsMDA RJ45 UTP Installing an MDA Replacing an installed MDA Installing a Gbic in an MDA Removing an Installed Gbic from an MDA Installing a Gbic1000BASE-LX Multimode Applications Removing a Gbic with spring tabs