Nortel Networks 302403-G manual Removing an Installed Gbic from an MDA, Installing a Gbic

Figure 11 Installing a GBIC

3Press on the front of the GBIC until it snaps into place.

4Remove the rubber plug to connect cables.

Removing an Installed GBIC from an MDA

For a description of the GBIC MDA, see “GBIC MDA” on page 22.

To remove an installed GBIC:

Do one of the following:

•If the GBIC has spring tabs (Figure 9 on page 23), press in on the tabs on each side of the GBIC as you pull the GBIC out of the MDA’s Host port (Figure 12).

29