Transcend Information 128MB-256MB JetFlash user manual Connect without an Access Point Ad Hoc Mode

Page 15

Connect without an Access Point (Ad Hoc Mode)

If you want to communicate with the other wireless devices directly (peer to peer) without using an Access Point, you must select Ad Hoc mode. Follow the procedures below to activate Ad Hoc Mode:

1.Execute the WLAN Utility.

2.Select the Setting tab in the IEEE 802.11b WLAN Utility (USB) window.

3.Select 802.11 Ad Hoc as the Network Type.

4.Select or type in the SSID, Country, and Channel.

Image 15

Contents USB Table of Contents Package Contents FeaturesSystem Requirements Switch LED LightsStatus Driver Installation for Windows 98SE Driver Installation for Windows Me, 2000, and XP Install the Wlan Utility Page Page Page Execute the Wlan Utility Ieee 802.11b Wlan Utility USB window will appear Connect to an Access Point Infrastructure ModePage Page Connect without an Access Point Ad Hoc Mode Select OK to activate 802.11 Ad Hoc Mode Enable Encryption Page Setting the Transmission Rate LAN Status Power Saving ModeLink Information About Version DiagnosticRemove JetFlash in Windows Me Remove JetFlash in Windows 98SERemove JetFlash in Windows Page Remove JetFlash in Windows XP Uninstall Wlan Utility Page ™ In Windows 98SE Troubleshooting™ In Windows Me Page ™ In Windows Select Hardware tab and then select Device Manager Page ™ In Windows XP Select Hardware tab and then select Device Manager Page Ordering Information Transcend Information, Inc