Transcend Information 128MB-256MB JetFlash user manual Install the Wlan Utility

Page 7

Wireless LAN Function

The WLAN Utility is JetFlash’s management software. You must install the WLAN Utility found on the Driver CD to enable the WLAN Function. Before installing the WLAN Utility, verify that the switch is set to the “ON” position and carefully read the following steps.

Install the WLAN Utility

1.Insert the Driver CD into the CD-ROM (Auto-Run supported). Select the WLAN Utility button.

2.Select Next.

3.Select Yes.

Image 7

Contents USB Table of Contents Features Package ContentsSystem Requirements LED Lights SwitchStatus Driver Installation for Windows 98SE Driver Installation for Windows Me, 2000, and XP Install the Wlan Utility Page Page Page Execute the Wlan Utility Ieee 802.11b Wlan Utility USB window will appear Connect to an Access Point Infrastructure ModePage Page Connect without an Access Point Ad Hoc Mode Select OK to activate 802.11 Ad Hoc Mode Enable Encryption Page Setting the Transmission Rate LAN Status Power Saving ModeLink Information About Version DiagnosticRemove JetFlash in Windows Me Remove JetFlash in Windows 98SERemove JetFlash in Windows Page Remove JetFlash in Windows XP Uninstall Wlan Utility Page ™ In Windows 98SE Troubleshooting™ In Windows Me Page ™ In Windows Select Hardware tab and then select Device Manager Page ™ In Windows XP Select Hardware tab and then select Device Manager Page Ordering Information Transcend Information, Inc