Transcend Information 128MB-256MB JetFlash user manual Setting the Transmission Rate

Page 19

4. Select Apply to finish.

Setting the Transmission Rate

JetFlash supports four kinds of transmission rates. You can follow the procedures below to set the transmission rate.

1.Execute the WLAN Utility.

2.Select the Setting tab and then select Advance.

3.Select one of following transmission rates and then select Apply to set the transmission rate.

Fully Auto (Default)

Fixed 11Mbps

Fixed 5.5Mbps

Auto 1 or 2Mbps

17

Image 19
Contents USB Table of Contents Features Package ContentsSystem Requirements LED Lights SwitchStatus Driver Installation for Windows 98SE Driver Installation for Windows Me, 2000, and XP Install the Wlan Utility Page Page Page Execute the Wlan Utility Ieee 802.11b Wlan Utility USB window will appear Connect to an Access Point Infrastructure ModePage Page Connect without an Access Point Ad Hoc Mode Select OK to activate 802.11 Ad Hoc Mode Enable Encryption Page Setting the Transmission Rate LAN Status Power Saving ModeLink Information About Version DiagnosticRemove JetFlash in Windows Me Remove JetFlash in Windows 98SERemove JetFlash in Windows Page Remove JetFlash in Windows XP Uninstall Wlan Utility Page ™ In Windows 98SE Troubleshooting™ In Windows Me Page ™ In Windows Select Hardware tab and then select Device Manager Page ™ In Windows XP Select Hardware tab and then select Device Manager Page Ordering Information Transcend Information, Inc