Ayre Acoustics 3-Phase Power Supply owner manual Configuring an AyreLink System

The unit will remain in configuration mode for ten seconds. During that time, pressing the front-panel button will change the default setting for the brightness of the status LED as noted below:

One press – Low brightness

Two presses – Medium brightness

Three presses – High brightness

After the ten-second configuration period has elapsed, the status LED will revert to green (”Standby” mode).

If no button presses are detected during the ten second period, the unit will revert to the factory default setting (high brightness).

Changes to the default settings will also be transmitted via the AyreLink communication system to other linked components. Therefore, changing the display brightness of the Ayre 3-Phase Power Supply will make the same change on all linked components.

Configuring an AyreLink System

When any AyreLink source component is changed to the “Operate” mode, it broadcasts that information to the other linked components. Part of the transmitted information is an alphabetical code that identifies the source of the broadcast. The

3-Phase Power Supply will transmit the identifier code “P”. This information can be used by other linked components to automate operation of the system.

11