Ayre Acoustics 3-Phase Power Supply owner manual Break-In, Standby

Page 11

Standby

A short press on the standby button of the Ayre 3-Phase Power Supply will turn that individual component off. A longer press (more than two seconds) will turn off all linked components.

A long button press provides a simple way to turn the entire system off from any linked component.

Display Brightness

Changing the brightness level on the display of any linked component will cause a matching change in all linked components, including the status LED of the 3-Phase Power Supply.

There is no directly accessible brightness control for the status LED on the 3-Phase Power Supply. However if there are no other linked components available to adjust the brightness, a special configuration mode allows the desired brightness level to be selected. Please refer to the chapter “Optimization and Customization”.

Break-In

Playing the unit for 100 to Due to the manufacturing processes used for the

500 hours will ensure full printed circuit boards, wires, and capacitors, a

break-in.break-in period is necessary for the Ayre 3-Phase Power Supply to reach its full performance potential.

9

Image 11
Contents Phase Power Supply Page Contents Dps / Ayre Introduction Motor Drive Output InstallationLocation AyreLink Ports AC PowerLinked components may be joined in any convenient order Status LED and Standby Button OperationOperate AyreLinkStandby Break-InDisplay Brightness CustomizationConfiguring an AyreLink System Page Specifications Overheating TroubleAC Line Voltage Status LED Summary North American Warranty WarrantyNorth American Warranty Statement International Warranty Place for Rev Page Ayre Acoustics, Inc Central Avenue Boulder, Colorado