MGE UPS Systems Pulsar EX 1500, Pulsar EX 700, Pulsar EX 1000 user manual Rack model

Page 23

4. Maintenance

Rack model

Removal of battery module

A- Remove the two screws securing the door. B - Slide the door open and remove it.

C - Unscrew the bar that holds the battery module in place. D - Remove the bar.

E - Disconnect the battery module. F - Remove the battery module.

B	A

C

D

E

F

Reinstallation of the battery module

Carry out the above operation in reverse order.

◗To maintain an identical level of performance and safety, use a battery module identical to that previously mounted in the UPS.

◗Press the two parts of the battery connector tightly together to ensure proper connection.

51031604EN/AA - Page 23

Image 23

Contents Pulsar EX Introduction Product safety SafetySafety rules Safety of personsPictograms Using this documentForeword Contents Shutdown Environment AppendicesTower model Rack model PresentationPulsar EX range Pulsar EX BackTower model Pulsar EX 700 / Pulsar EXUSB 20% Control panelUnpacking and checks Installation12 51031604EN/AA Rack mounting diagram with rails Installation of the rack versionConnection to the RS 232 or USB communications port optional Installation of the communications-card option Connections LEDs 12 to 15 provide three different indications OperationStart-up Bargraph indicationsSleep mode Transfer to battery powerThreshold for the low-battery warning End of backup timeOn / OFF conditions tab Battery tabPersonalisation optional FunctionBypass tab ShutdownOutput tab Troubleshooting MaintenanceReinstallation of the battery module Replacement of the battery moduleSafety rules Removal of battery moduleRack model Packing UPS recycling at the end of service lifeEnvironment This product has been designed to respect the environmentAppendices Technical characteristicsSimplified diagram Operating conditions UPS GlossaryConnection Index28 51031604EN/AA