MGE UPS Systems Pulsar EX 700, Pulsar EX 1000 Safety rules, Safety of persons, Product safety

Page 3

Safety

Safety rules

Safety of persons

A UPS has its own internal power source (the battery). Consequently, the power outlets may be energised even if the UPS is disconnected from the AC-power source.

Dangerous voltage levels are present within the UPS. It should be opened exclusively by qualified service personnel.

The UPS must be properly earthed. Measurements are required to ensure that the total leakage current of the UPS and the protected equipment does not exceed 3.5 mA.

The battery supplied with the UPS contains small amounts of toxic materials. To avoid accidents, the directives listed below must be observed:

Never burn the battery (risk of explosion).

Do not attempt to open the battery (the electrolyte is dangerous for the eyes and skin).

Comply with all applicable regulations for the disposal of the battery.

Batteries constitute a danger (electrical shock, burns). The short-circuit current may be very high. Precautions must be taken for all handling.

Product safety

UPSs must be connected to a nearby wall outlet that is easily accessible.

The UPS can be disconnected from the AC-power source by removing the power cord.

Never install the UPS near liquids or in an excessively damp environment.

Never let a foreign body penetrate inside the UPS.

Never block the ventilation grates of the UPS.

Never expose the UPS to direct sunlight or a source of heat.

Special precautions

The UPS connection instructions contained in this manual must be followed in the indicated order.

Check that the indications on the rating plate correspond to your AC-power system and to the actual electrical consumption of all the equipment to be connected to the UPS.

If the UPS must be stored prior to installation, storage must be in a dry place. The admissible storage temperature range is -20°C to +45° C.

If the UPS remains de-energised for a long period, we recommend that you energise the UPS for a period of 24 hours, at least once every month. This charges the battery, thus avoiding possible irreversible damage.

Prior to handling the battery:

remove all watches, rings, bracelets and any other metal objects;

use tools with insulated handles.

51031604EN/AA - Page 3

Image 3
Contents Pulsar EX Introduction Product safety SafetySafety rules Safety of personsUsing this document ForewordPictograms Contents Shutdown Environment AppendicesPresentation Pulsar EX rangeTower model Rack model Pulsar EX BackTower model Pulsar EX 700 / Pulsar EXUSB 20% Control panelUnpacking and checks Installation12 51031604EN/AA Rack mounting diagram with rails Installation of the rack versionConnection to the RS 232 or USB communications port optional Installation of the communications-card option Connections LEDs 12 to 15 provide three different indications OperationStart-up Bargraph indicationsSleep mode Transfer to battery powerThreshold for the low-battery warning End of backup timeOn / OFF conditions tab Battery tabPersonalisation optional FunctionShutdown Output tabBypass tab Troubleshooting MaintenanceReinstallation of the battery module Replacement of the battery moduleSafety rules Removal of battery moduleRack model Packing UPS recycling at the end of service lifeEnvironment This product has been designed to respect the environmentTechnical characteristics Simplified diagram Operating conditionsAppendices UPS GlossaryConnection Index28 51031604EN/AA