MGE UPS Systems Pulsar EX 1500 Connection to the RS 232 or USB communications port optional

Page 14

2. Installation

2.3 Connection to the RS 232 or USB communications port (optional)

25

RS232 USB

26

23

1 - Connect the RS 232 25 or USB 26 communications cable to the serial port or the USB port on the computer.

2 - Connect the other end of the communications cable 25 or 26 to the RS

2322 or USB 3 communications port on the UPS.

The UPS can now communicate with all MGE UPS SYSTEMS supervision, set-up or safety software.

3

2

The RS 232 and USB communications ports cannot operate simultaneously.

Page 14 - 51031604EN/AA

Image 14

Contents Pulsar EX Introduction Safety of persons SafetySafety rules Product safetyPictograms Using this documentForeword Contents Environment Appendices ShutdownTower model Rack model PresentationPulsar EX range Pulsar EX 700 / Pulsar EX BackTower model Pulsar EXUSB Control panel 20%Installation Unpacking and checks12 51031604EN/AA Installation of the rack version Rack mounting diagram with railsConnection to the RS 232 or USB communications port optional Installation of the communications-card option Connections Bargraph indications OperationStart-up LEDs 12 to 15 provide three different indicationsEnd of backup time Transfer to battery powerThreshold for the low-battery warning Sleep modeFunction Battery tabPersonalisation optional On / OFF conditions tabBypass tab ShutdownOutput tab Maintenance TroubleshootingRemoval of battery module Replacement of the battery moduleSafety rules Reinstallation of the battery moduleRack model This product has been designed to respect the environment UPS recycling at the end of service lifeEnvironment PackingAppendices Technical characteristicsSimplified diagram Operating conditions Glossary UPSIndex Connection28 51031604EN/AA