OVER
25% 50% 75% 100% LOAD
INVERTER LOAD
AWAY
TEST
MUTE HOME
INVERTER | ON | ON |
DISABLE | MAINS BATTERY FAULT |
Figure 4. Home UPS Front Panel Controls and Indicators
Table 1. Home UPS Indicators
Mode
ON LINE
ON LINE SELF TEST
ON BATTERY SELF TEST
ON BATTERY
BATTERY DISCONNECTED
Short Circuit (heavy overload)
ON BATTERY Low Battery Warning
On
Mains
(green)
On
Flashing Flashing
Off
On
Off
Off
On
Battery (yellow)
Off
Off
On
On
Off
Off
On
Fault (red)
Off
Off
Off
Off
Flashing
On
Off
INV
Disable
(red)
Off
Off
Off
Off
Off
Off
Off
Buzzer
Off
Off
Off
Chirp every 2 seconds
Continuously On
Constant Beeping, Can be muted through front panel TEST/MUTE push button.
Description
The unit is
The unit is in
The unit is in
The unit is in
The unit is
The unit is in FAULT state, due to short circuit fault.
Power Meter
Power Meter
Power Meter
Power Meter
25%
on
on
on
on
50%
off
on
on
on
Table 2. Load Indications
75% | 100% | Overload |
off | off | off |
off | off | off |
on | off | off |
on | on | off |
|
|
|
Buzzer
off
off
off
off
Description
The unit is in
The unit is in
The unit is in
The unit is in ON BATTERY mode; the load is between 75% and the overload limit.
NOTE: In the case of a sustained overload, the Home UPS will be turned off automatically after one minute, and will wait in the fault state for a minute. After that, it will restart again. If the overload still persists, the Home UPS will be turned off again after one minute, and will wait in fault state for one minute and restart again. In the same way, it will try for three restarts. If the overload still persists, it will stay in fault state permanently until the unit is restarted with push button. If the time interval between two consecutive overloads is more than 5 minutes, then the latest overload is considered as a fresh overload and three restart cycle will begin again.
Page 4