American Power Conversion 200-240 VAC, 8000VA user manual XLT/XLJ/XLTW Models

Page 5

7.XLI model only: For three-phase input, set the Input Phase Selector switch (see C) to ‘3’. For single-phase input, leave switch in default position of ‘1’.

XLT/XLJ/XLTW MODELS

OUTPUT

L1A

L2A

INPUT

XLI MODEL

8.Switch the circuit breakers ON.

9.Check line voltages.

10.Replace the access panel.

OUTPUT

L1A

INPUT

Image 5

Contents

APC Smart-UPSRT Page Introduction SpecificationsUnpacking Removing the BatteriesWiring must be performed by a qualified electrician HardwiringXLT/XLJ/XLTW Models Page L6-20 L6-30 250V 20A 250V 30A External Battery Pack Connectors Operation Affect the voltage display On Battery OperationUser Configurable Items XLJ models Adhere to national and local electrical codes when wiring EPO Emergency Power Off OptionTerminal Mode to Configure UPS Parameters Transporting the UPS Replacing the Battery ModulesTroubleshooting Replace Battery LED flashes Limited Warranty Service200, 208, 220, 230, 240 V Models Regulatory Agency Approvals and Radio Frequency WarningsDeclaration of Conformity APC Worldwide Customer Support