CONNECTING POWER AND EQUIPMENT TO THE UPS
1.Hardwire the UPS (see Hardwiring).
2.Connect equipment to the UPS (cables not included for XLT/XLJ/XLTW models).
3.Turn on all connected equipment. To use the UPS as a master on/off switch, be sure that all connected equipment is switched ON.
4.Press the 
button on the front panel to power up the UPS.
•The battery charges to 90% capacity during the first three hours of normal operation. Do not expect full battery run capability during this initial charge period.
5.Configure the Web/SNMP management card (optional).
OPTIONS
Refer to the APC web site, www.apc.com for available accessories.
External Battery Pack SURT192XLBP
Rail Kit SURTRK2
Isolation Transformer
Service Bypass Panel
CIRCUIT BREAKERS
Input Circuit Breaker 7500/10000 VA XLI/XLJ/XLT/XLTW
The UPS is protected from extreme overloads when in ON position. The breaker must be on for the UPS to operate.
Output Circuit Breaker 7500/10000 VA XLJ/XLT/XLTW
|
|
250V 20A | 250V 30A |
Output Circuit Breaker 7500/10000 VA XLI
IEC | IEC |
10A for each | 16A for each |
receptacle | receptacle |
5