American Power Conversion 7500/10000 VA user manual Operation

Page 9

2:OPERATION

FRONT DISPLAY PANEL

Indicator

Description

 

 

Online

The UPS is drawing utility power and performing double conversion to supply

 

power to connected equipment (see Troubleshooting).

 

 

On Battery

The UPS is supplying battery power to the connected equipment.

 

 

Bypass

The UPS is in bypass mode, sending utility power directly to connected equipment.

 

Bypass mode operation is the result of an internal UPS fault, an overload condition

 

or a user initiated command either through an accessory or the manual bypass

 

switch. Battery operation is not available while the UPS is in bypass mode (see

 

Troubleshooting).

Fault

The UPS detects an internal fault (see Troubleshooting).

 

 

Overload

The connected loads are drawing more power than the UPS power rating (see

 

Troubleshooting).

 

 

Replace

The battery is disconnected or must be replaced (see Troubleshooting).

Battery

 

 

 

 

 

Feature

Function

 

 

Power On

Press this button to turn on the UPS. (Read on for additional capabilities.)

Power Off

Press this button to turn off the UPS.

7

Image 9
Contents APC Smart-UPSRT Page Introduction PlacementUnpacking Removing the BatteriesXLT, XLJ, and Xltw Models HardwiringXLT/XLJ/XLTW Models Page L6-20 L6-30 250V 20A 250V 30A Serial Port Operation Affect the voltage display On Battery OperationUser Configurable Items Models Adhere to national and local electrical codes when wiring EPO Emergency Power Off OptionTerminal Mode to Configure UPS Parameters Replacing the Battery Modules StorageTransporting the UPS Troubleshooting Replace Battery LED flashes Contacting APC Service200, 208, 220, 230, 240 V Models Regulatory Agency Approvals and Radio Frequency WarningsDeclaration of Conformity Limited Warranty