Left Front | American Power Conversion 5000RMB guide

Install the Mounting Rails in the Rack
1.	Determine where in the rack you will mount the UPS. The
	SU5000 requires a space of 5U. Some racks have tick marks to
	indicate the U-spaces.
2.	Using the mounting template provided (part number 990-0195),
	identify and mark the correct mounting holes for the UPS
	mounting brackets.
3.	Locate and mark the bottom hole in the designated U-space n.
n	The bottom screw on the mounting rail will attach to the bottom
n	hole in the U-space.
4.	Repeat steps 2 and 3 for the remaining three rack posts.
5.	Prepare the rack holes, if necessary. Racks with threaded holes
	require no preparation.
	If your rack has round holes, insert clip nuts	(provided) into
	the holes marked in step 2.
	If your rack has square holes, insert either clip	or cage
	nuts into the holes marked in step 2.
6.	Align the bottom hole on the mounting rail with the bottom hole
	in the U-space (marked in step 3 above). Position the rails so
	that the lip of the rail is on the bottom.
	Note: The rails are marked “L” and “R.” Mount the rail labeled
	“L” on the left-hand side of the rack and the rail labeled “R” on
Left Front	the right-hand side of the rack.
Left Front
Rack Post	Use the flat, Phillips head screws (10-32) and conical washers to

	attach the front rail to the rack. Attach the rails to the rack using
	three (3) screws per rail, as shown.
7.	Expand the rails so that it spans from the front rack post to the
	back rack post.

8. Attach the rail to the back rack post using the same hardware (10-32 flat head screws and conical washers) used in step 6. Repeat steps 6 through 8 for the other rails.

Right Rear Rack Post