REMOVING THE BATTERY TRAYS FROM THE BATTERY PACK
The battery pack is heavy. To lighten it, remove the battery trays before mounting the unit in the rack.
The battery trays are accessible from the front of the battery pack (shown at left). This procedure requires a Phillips screwdriver.
Π|
| Π| 1. | Notice that the two battery tray compartments Π|
|
|
| ||
|
|
|
| are visible. This procedure describes how to re- |
|
|
|
| move one battery tray. |
Ž | Ž |
| 2. | Locate the white cord attached to the battery tray |
|
|
|
| connector plug •. Grasp the cord and pull firmly |
|
|
|
| toward you until the connector plug is discon- |
|
|
|
| nected. |
|
|
|
| DO NOT pull the battery cables. |
|
|
| 3. | Use a screwdriver to remove the two battery pack |
|
|
|
| mount screws located at the top corners of the |
| • |
|
| face plate Ž. |
|
|
|
| Set the screws aside in a safe place. You will re- |
|
|
|
| place them later. |
|
|
| 4. | Locate the battery tray handle •. |
|
|
| 5. | Be careful during this |
|
|
|
| heavy. |
|
|
|
| Pull the battery tray handle toward you to slide |
|
|
|
| the tray out of the battery pack. |
|
|
|
| DO NOT pull on battery cables or white cord. |
• |
|
| 6. | Repeat Steps 2 through 5 to remove the other the |
|
|
|
other tray.
MOUNTING THE BATTERY PACK IN THE RACK
1.Supporting the battery pack on both sides, care- fully align the unit with the rails. Use the handles Πon the side of the battery pack to support the unit.
Π|
| 2. Each side of the battery pack has a cleat • that |
|
| must slide into the groove on the rails. Insert each |
|
| cleat into its groove and slide the battery pack |
|
| into position. |
Œ | • | 3. Use the four ornamental screws supplied with the |
| ||
|
| battery pack to attach the mounting brackets to |
|
| the rack post. Insert the screws into the top and |
|
| bottom holes in the |
|
| 5 |