Operation
Connect Equipment to the UPS
Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery runtime capability during this initial charge period.
1.Connect equipment to the outlets on the rear panel of the UPS.
2.Connect the UPS to the building utility power. Connect the UPS to a
3.Press the ON/OFF button on the front panel of the UPS to power the unit and all connected equipment.
4.To use the UPS as a master on/off switch, turn on all the equipment that is connected to the UPS.
See “Switched Outlet Groups” on page 11 for information on how to use the Switched Outlet Groups.
su0475a
Basic Connections
Serial port: Connect to a computer to use power management software, use the serial cable included with the unit.
USB port: Connect to a computer to use power management software.
Note: Serial and USB communication can only be used individually, they cannot communicate at the same time.
External Battery Pack connector: Connect XLBPs to provide extended runtime during power outages. The UPS can support up to 10 external battery packs.
Ground Screw: The UPS features a ground screw for connecting the ground leads on transient voltage devices. Prior to connecting a ground lead, disconnect the UPS from utility power.
4 |