Anton/Bauer DUAL 2722 owner manual FCC Notice, Specifications, FUSE/TYPE Replacement

Page 14

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This equipment has been approved by one or more agencies. All changes and/or modifications not expressly approved by Anton Bauer, Inc. could void the users’ warranty and authority to operate this equipment. There are no serviceable parts in this equipment.

SPECIFICATIONS

Size

7.75” x 8.50” x 3.13”

Weight

2.75lbs. (1.25kg)

Input Voltage

90-264VAC 50/60 Hz

Output Voltage*

16 VDC

Maximum Power*

70 watts at 16 volts

Fuse Rating

5 amp (PCB Mounted)

*IN CAMERA POWER MODE AT 4 PIN XLR CONNECTOR.

FUSE/TYPE REPLACEMENT

The fuse of the DUAL 2722 is a PCB mounted device which should only be replaced by a qualified service technician.

11

Image 14
Contents PowerCharger Dual Page Table of Contents Features IntroductionSafeguards GROUNDING/EARTHINGCharging ApplicationsThree Stage Charging Methodology LED Indications LED Indication MeaningVCO Wait 2-READYPropac DDM DIAGNOSTIC/DISCHARGE Module To Operate The DDM Autocal Feature Operation AS DC Camera Supply from Mains FCC Notice SpecificationsFUSE/TYPE Replacement Warranty