Banner American Products MIGHTYLAM 2700 guide

4.Pull 6”-12” of film from the bottom roll. Pass it under the lower idler bar. You can “drop-down” the lower idler bar to give you more clearance. After doing so, return the idler bar to its upper position for running the machine. Drape the film from the bottom roll over the film from the top roll. See figures 5&6.

FIGURE 5

FIGURE 6

NOTE: The shiny side of the film must always go against the heat shoes.

The heat shoes reach a temperature of up to 350°F. Do not touch the surface of the heat shoes.

5.Turn the Motor Switch on to start the Laminating and Pull Rollers.

6.Feed a piece of thin cardboard about 10” x 25” against the film so that it is centered between the two heat shoes. Push the cardboard and film into the laminating rollers. See figure 5. Watch cardboard pass through the back (pull) rollers to avoid a wrap-around.

7.When the feed card has completely exited the pull rollers at the rear of the laminator turn the motor switch off.

8.Replace the feed table.

9.If you are ready to laminate, the heat switch should be in the on position and the heat indicator should have gone off.