Caution! If the blade release knobs are turned too far, the slitter blade may fall out of its guide and come in contact with the rubber rollers. If this happens, the rollers could be damaged. Never turn the blade release knobs more than one turn to position the blades.
To Adjust the Slitter Blades:
1.Be sure the slitter blades are positioned above the laminating web. If they are lowered, loosen the release screws and lift the blades away from the web. Tighten the screws to lock the blades in place.
2.Loosen the positioning screws (counter clockwise) and slide the slitter blades left or right to the desired width of the edge seal. Lock the blades left or right to desired position by turning the positioning screws (clockwise).
3.Carefully, loosen each release screw and lower the blade in contact with the web. Tighten the release screw.
4.To prevent accidental damage to rollers, remove slitter blades when not in use.
Figure 8
Laminating…
1.Be sure the heaters have been turned on and are at the proper temperature. The fans should be turned on for laminating 3mil and heavier.
Caution! Do not allow the temperature to exceed 350°F as this could cause the laminating film to melt on the heat shoes.
2.Adjust the Paper Guide on the Feed Table so that the right edge of the item will enter the laminator at the desired position.
3.Press the motor switch to the on position. The film will begin moving through the laminator. Please turn off fans when the motor is not running.
4.After clear laminating film exits the pull rollers at the rear of the machine you may feed the first item to be laminated into the laminator with the right side along the paper guide.
11