Shindaiwa DG150MI Stopping the Generator Protection⑥ Features, Adjustment During operation

Turn the switch and the circuit breaker for the load equipment to OFF

Turn the circuit breaker for single-phase and 3-phase on the control panel to OFF position Loosen the locknut for the Speed Control knob

Press the Speed Control knob all the way in, while pressing Release Button, and let the engine idle at 1000min-1

Keep the engine idle (cooling down) for at least 3 minutes Turn the starter switch to STOP position

Add fuel to the fuel tank

Loosen the air extracting plug to remove the air out. Tighten the plug, ensuring all the air out. Turn the starter switch to <Operating/Preheating> position. It will take approximately 10 seconds to vacuum the air out.

9.2.2Adjustment During operation

￿Make minor adjustment to voltage and speed using the Speed Control Knob and Voltage Regulator, by monitoring Tachometer, frequency meter, and voltage meter

■Vacuuming the air out of the fuelling system in event of no fuel Refer to the <User’s manual for Engine> separately.

✳This generator is equipped with automatic vacuuming air feature. Thus if the engine stops due to running out of fuel, follow the next steps to vacuum the air out.

<Caution> ③

①

Ensure that all the air is completely extracted from fuel line, by pushing the speed control knob all the way out and start the engine.

②

In the case air is in the fuel line, the engine speed is unstable, and proceed with the vacuuming steps again.

9.3 Stopping the Generator

①

②

③

9.4 Protection⑥ Features

④

⑤

This generator is equipped with automatic shutdown feature and display of the location of alarm, in event of any alarm situation. In event of the automatic shutdown or alarm lamp flashing, turn off the engine and investigate the alarm.

- 32 -