! Caution

:Burns

￿Do not open the radiator cap while operating this equipment or immediately after stopping the equipment, to avoid sustaining burns from hot vapor.

￿Do not touch the engine and muffler during operation and immediately after stopping the equipment, for the temperature can reach extremely high.

Check the radiator and coolant reservoir tank for water and add water in case of shortage.

8.2.1Checking Radiator / Adding water

Remove the radiator cap

Fill up the radiator up to the top

Install the cap back and tighten

<Caution>

With respect to DG150MI, check and add water, after unscrewing the bolt holding the radiator cap.

8.2.2 Checking Coolant reservoir tank / Adding coolant

Check to see if the coolant level is between MIN and MAX line

Fill up to the MAX line, if the coolant level is low

<Caution>

￿ Use soft water, such as tap water

￿ If the outside temperature is near freezing, use Long Life Coolant (LLC)

(30% mixture LLC is used, when shipped from factory) ￿ Use same type of coolant with identical mixture ratio

for the reservoir tank

￿ Mixture ratio of the coolant should be between 30 to 45%, depending on the outside temperature

￿ Replace LLC every 2 years or 400 hours

Mixture ratio (for reference only)

Ambient

 

 

temperature

-15

-20

(Celsius)

 

 

Mixture ratio

30%

35%

 

 

- 26 -

-30 45%

Page 26
Image 26
Shindaiwa DG150MI, DG250MI specifications Checking Radiator / Adding water, Checking Coolant reservoir tank / Adding coolant