8.2.3 | Coolant Capacity |
|
|
|
| |||
|
|
|
|
|
| (Unit : L) | ||
|
|
|
|
|
|
|
|
|
|
|
|
| Total Coolant Volume | (including reservoir tank) |
| ||
|
|
|
| DG150MI |
| 7.4 (0.4) |
|
|
|
|
|
| DG250MI |
| 8.5 (0.4) |
|
|
|
|
| Value in ( ) shows the reservoir tank’s volume | |||||
|
| ＊ |
|
|
|
|
| |
8.3 Checking Fan Belt |
|
|
|
| ||||
✳ | Also refer to the user’s manual for Engine separately | |||||||
! | Danger | :Injuries |
|
|
|
| ||
|
|
|
|
|
|
| ||
Before performing any equipment check or maintenance, stop the engine, and remove the engine | ||||||||
| key. A person performing the maintenance should always keep the key. | |||||||
Close all doors and place locks during operating this equipment, to avoid injuries by unintentionally | ||||||||
|
| touching cooling fan and fan belt. |
|
|
|
| ||
! Caution
:Burns
Do not touch the engine and muffler during operation and immediately after stopping the equipment, for the temperature can reach extremely high.
8.3.1Tension
Tension should be optimum when the fan belt has 8 to 12mm slacks, when applying finger pressure (about 98N{approximately 10kgf}) at midpoint between fan pulley and alternator pulley.
8.3.2 Condition
Check for any damage on the fan belt. Replace if necessary.
<Caution>
Refer to the <User’s manual for Engine> for adjusting and replacing of the fan belt.
- 27 -
