5.2.3 Water Temperature Gauge [DG250MI only]

Water Temperature Gauge displays the temperature of engine coolant. Normal temperature may vary depending on the environment, but it should be between 75 to 90 degree Celsius.

<Caution>

If the temperature exceeds normal value, disconnect the load, idle the engine at 1000min-1, and wait until the reading falls to the normal temperature range.

5.2.4 Oil Pressure Gauge [DG250MI only]

Oil Pressure Gauge displays the pressure of engine oil. Normal pressure may vary depending on the environment, but it should display 2.9 – 4.9 x 100kPa (3-4kgf/cm2). However, under cold weather, the pressure gauge may display higher reading. Continue idling until the pressure falls to normal range.

5.2.5Generator Gauges

5.2.5.1Voltage Meter

Voltage Meter displays the voltage output (Phase to Phase) from the generator.

5.2.5.2 Amp Meter

Amp Meter displays the electrical (Phase) current output from the generator.

5.2.5.3 Frequency Meter

Frequency meter will display the frequency of the power source

5.2.6Lamp

5.2.6.1Preheat Lamp

When the start switch is turned to <Operation or Pre-heating> position, the Preheat Lamp will be turned. When preheating is completed, preheat lamp turns off and operation can start.

<Caution>

Pre-heating may vary depending on the environment, but it should finishes in about 1-5 seconds.

- 13 -

Page 13
Image 13
Shindaiwa DG150MI Water Temperature Gauge DG250MI only, Oil Pressure Gauge DG250MI only, Generator Gauges, Lamp