okiDoc
Continuous Forms:
Setting Forms Tear-Off and Top of Form
The Forms
Top of Form (TOF) is the place on the sheet where the first line of printing begins.
Forms
Important!
Do not turn the platen knob (on the right hand side of the printer). Doing this will always change the TOF setting. If you must use the platen knob to remove paper jams or to move the paper, be sure to turn the printer off first.
If necessary, the TOF can be reset back to the factory default by pressing the QUIET/TOF button with paper parked out of the printer, or by turning on the printer while holding the QUIET/TOF and PARK buttons.
!Your software may print the first line above or below the Top of Form setting. If this happens, you must reset
the Top of Form according to you software’s needs.
How to Determine the Current Setting for Forms Tear-Off
Before setting the Top of Form you need to verify the Forms
SEL |
|
|
|
|
|
SEL |
| LF | FF/LOAD | TEAR | PARK QUIET |
MENU | SHIFT | Micro Feed | Micro Feed |
| TOF |
|
| Down | Up |
|
|
EXIT |
| GROUP | ITEM | SET | |
POWER | ALARM | MENU |
|
|
1.Make sure paper is loaded and the printer is turned on.
2.Press TEAR:
•If the paper moves up, Forms
•If the paper moves down, Forms
How to Change the Current Setting for Forms Tear-Off
SEL |
|
|
|
|
|
SEL |
| LF | FF/LOAD | TEAR | PARK QUIET |
MENU | SHIFT | Micro Feed | Micro Feed |
| TOF |
|
| Down | Up |
|
|
EXIT |
| GROUP | ITEM | SET | |
POWER | ALARM | MENU |
|
|
1.Make sure paper is loaded and the printer is turned on.
2.Hold SHIFT and press SEL.
The printer enters the Menu mode.
3.Press GROUP (LF) until the paper path (e.g., Rear Feed) for which you wish to set the Forms
Rear Feed | Line Spacing | 6 LPI |
4.Press ITEM ((FF/LOAD) until Form
Rear Feed Form | Off |
5. Press SET (TEAR) to change the setting, e.g.:
Rear Feed Form | On |
6.Hold SHIFT and press SEL to save the new setting and exit the Menu mode.
Setting Top of Form (TOF)
With Forms Tear-Off Set to OFF
SEL |
|
|
|
|
|
SEL |
| LF | FF/LOAD | TEAR | PARK QUIET |
MENU | SHIFT | Micro Feed | Micro Feed |
| TOF |
|
| Down | Up |
|
|
EXIT |
| GROUP | ITEM | SET | |
POWER | ALARM | MENU |
|
|
1.Turn the printer ON.
2.Press SELECT to take the printer off line. The SEL light goes out.
3.Press and hold SHIFT, then press LF/Micro Feed Up to move the TOF location down on the page or FF/ LOAD/Micro Feed Down to move the TOF location up.
4.Keep holding SHIFT and press QUIET/TOF a few times to engage the new setting.
5.Press SELECT to place the printer back on line.