Hardware problems
Symptom | Problem | Solution |
|
|
|
Graphic image prints | Insufficient printer | Change the resolution, |
partly on one page, | memory for this image | reduce the image size, |
partly on the next. | at this resolution. | or install more |
|
| memory in your |
|
| printer. |
|
|
|
When you try to print | Configuration error. | Check cable |
nothing happens, but |
| connection. If more |
printer indicates it is |
| than one printer is |
ready to receive data. |
| available, make sure |
|
| your printer has been |
|
| selected. |
|
|
|
Garbage prints. | Incorrect cable | Check cable |
| configuration. Also, | configuration, |
| see Software | continuity, and length. |
| Problems. |
|
|
|
|
Odours. | Gases are given off by | Make sure the forms |
| forms or adhesives | you use can withstand |
| passing through the hot | heating, and provide |
| fusing unit. | adequate ventilation. |
|
|
|
Printer is on but must | Power Save mode is | To eliminate warm up |
warm up before a job | set on to conserve | delay, change Power |
is printed. | energy. The fuser must | Save setting. |
| heat up before you can |
|
| begin printing the next |
|
| job. |
|
|
|
|
18 | OKIPAGE 8w Lite |