Epson MP-4000 Adjusting the Paper Width, Command Set Configuration, Print Mode Configuration

Page 19

MP-4000 TH . Revision 1.2

25.1.Adjusting the Paper Width

To adjust the paper width simply pull the spacer up and insert it in the desired position, according to the paper width desired. The figure below helps to identify the correct position, in compliance with the paper width. Note that for 82.5 mm paper width the spacer is not used at all. Keep it stored if in the future you will need to change back to a different paper width.

26.Command Set Configuration

In this section you can configure the command set that the printer will recognize when receiving printer commands from the host system.

You can configure to Bematech or ESC/POSTM.

27.Print Mode Configuration

In this section you can configure the Print Mode according to your needs. You can configure to High Quality or High Speed.

The factory default setting is High Speed.

Image 19

Contents Page Page Contents Chapter Troubleshooting How this manual is organized? Where to find more informationPreface Who should read this manual?RoHS FCC Compliance StatementDisposal and Recycling Information End of Life Disposal NOM-019-SCFI-1998End of Life Disposal Safety InformationSafety Labels Protection FeaturesIntroduction Product OverviewDescription of Models Product CharacteristicsSoftware and Drivers Typical ApplicationsOptional Items and Accessories Installing Plugging in the Power Adapter Inserting or Changing the Paper Roll Turn on Your Product Cash Drawer Connection Connecting the Communication Cables Connection of the communication Interface boards Language Configuration ConfiguringPaper Width mm Print Width mm Print Density ConfigurationNear End Paper Sensor Configuration Paper Width / Print Width ConfigurationCommand Set Configuration Adjusting the Paper WidthPrint Mode Configuration Dip Switches Communication Interface ConfigurationInserting or Changing the Communication Interface On DIP Cable Connection Pin Signal Direction DescriptionSignal SPP Parallel Interface SpecificationEthernet Interface Specification USB Interface SpecificationPino Sinal RCT GND Pin SignalDrawer type Others A-C Bematech/Epson B-D Cash Drawer InterfaceKeyboard User InterfaceLEDs Operation Modes Normal ModeSelf Test Mode Configuration Mode For Configuration Mode go to chapterSpooler Drivers Dump ModePreventive Maintenance Software Drivers API DriversSensors External CleaningCutter Ascii Problem Possible Cause ProcedureIf this doesn’t solve the problem, please don’t try to Characteristics Specification Page