Autocutter | TM200 Service Manual |
| |
Partial cut: | Cutting with one point center uncut |
| (selectable by ESC I or GS V) |
Full cut: | Cutting without uncut (selectable by ESC i ) |
Note:
To prevent dot displacement, after cutting, paper must be fed approximately 1 mm (14/360 or 0.04 inch) or more before printing.
Paper Specifications
Paper type: | Specified thermal roll paper |
Form: | Paper roll |
Paper width: | 79.5 ±0.5 mm (3.13" ± 0.02") |
Paper roll size: |
|
Roll diameter: | Maximum 83 mm (3.27") |
80 + 0.5 / | |
Paper roll diameter: | Inside: 12 mm (0.47") |
| Outside: 18 mm (0.71") |
CAUTION:
Paper must not be pasted to the paper roll.
Printable Area
Paper roll | The printable area of a paper with width of 79.5 ± 0.5 mm |
| (3.13" ± 0.02") is 72.2 ± 0.2 mm (2.84" ± 0.008") (576 dots) |
Internal Buffer |
|
Receive buffer selectable as 2KB or 96KB using the DIP switch.
Electrical Specifications
Supply voltage: | +24 VDC ± 7% Current consumption (at 24V, normal |
| temperature) |
Mean: Approximately 1.8A | |
| (Font A alphanumeric character printing for all columns) |
| Peak: Approximately 7.8A |
Standby: | Mean: Approximately 0.2A |
Note :
Maximum 1A for drawer
- 3 -