Belkin P74393UK manual Section

Page 34

Troubleshooting

If the Print Server has been configured before, and the IP address has already been set to another subnet, the best solution is to restore factory defaults on the Print Server. Do this by holding down the reset button while repowering the Print Server. After a reset, the Print Server will generally receive an IP address in the correct subnet.

“No printer” error screen appears during setup. In most cases, this error occurs when the printer is not powered on, or it is not enabled (or online). After you have checked this, make sure that it is not out of paper or jammed. Some printers “sleep” after periods of inactivity. In any of these cases, restore the printer to functionality, then, if necessary, reboot the Print Server. Some USB printers are not compatible with Print Servers. To check the Belkin website for compatibility information, go to: http://web. belkin.com/support/F1UP0301.

1

2

3

4

5

6

7

8

9

10

section

31

Image 34
Contents Port USB Print Server Wired Table of Contents Advantages of a wireless network IntroductionWireless Comparison Wireless Networking SpeedIntroduction Advantages of a wired network Combining wired and wireless technologiesPlacement of your Wireless Networking Hardware Introduction Overview LAN LED Knowing your Print Server PowerLEDError Status LEDOverview Reset/Test Button 3 functionsPrinter 1/Printer Connecting the Print Server Using the Setup Wizard Connecting the Print Server Using the Setup Wizard Install Print Drivers Setup for Advanced UsersSet Up Print Server Setup for Advanced Users Configure Computers to Print to the Print Server Setup for Advanced Users Web Configuration Accessing the Web Configuration MenusWeb Configuration Web Interface HomeWeb Interface Login Screen Web Interface IP AddressWeb Interface Print Server Configuration Web Interface Upgrade FirmwareWeb Interface System Settings Changing Password Printing to Multiple Print Servers Section Printing to Multiple Print Servers Belkin Port Monitor Advanced Menu Opening the Belkin Port Monitor Advanced MenuBelkin Port Monitor Advanced Menu Click the Advanced tab Using the Print Server for FTP Printing Section Using the Print Server for FTP Printing Section Troubleshooting Cannot find Print ServerSection Troubleshooting Installation CD-ROM does not start Setup Utility Technical Support Europe 00 800 223 55 Australia 1800 666Information FCC StatementInformation ModificationsSection