Belkin P74393UK manual Accessing the Web Configuration Menus

Page 18

Web Configuration

Accessing the Web Configuration Menus

1.Connect the included Ethernet cable into the Print Server and to an available Ethernet port on your router or switch.

2.Power up the Print Server. Allow approximately one minute for the Print Server to boot and obtain an IP address.

3.Determine the Print Server’s IP address, using one of the following methods:

a)New Print Servers are configured to receive IP addresses dynamically. If your network has a DHCP server, the Print Server will obtain an IP address from your network. If the DHCP server supports a client list, the client list will list the IP address assigned to the Print Server. If a DHCP server is not available, after 1.5 minutes the Print Server will revert to 192.168.2.253.

b)If the Print Server has been configured previously, then it will have been set to a static IP address that could be different for every network.

Note: Restoring factory defaults on the Print Server by holding in the reset button for 10 seconds while repowering the Print Server will restore the IP address to dynamic.

c)Run the program “PSF.exe” from the Installation CD. This will find the IP address and link automatically to the web-based management interface.

d)Go to the last step of the Print Server Installation Wizard, which has an Advanced button that finds the IP address and links automatically to the web-based management interface.

1

2

3

4

5

6

7

8

9

10

section

15

Image 18
Contents Port USB Print Server Wired Table of Contents Advantages of a wireless network IntroductionWireless Networking Speed Wireless ComparisonIntroduction Advantages of a wired network Combining wired and wireless technologiesPlacement of your Wireless Networking Hardware Introduction Overview LAN LED Knowing your Print Server PowerLEDError Status LEDReset/Test Button 3 functions OverviewPrinter 1/Printer Connecting the Print Server Using the Setup Wizard Connecting the Print Server Using the Setup Wizard Setup for Advanced Users Install Print DriversSet Up Print Server Setup for Advanced Users Configure Computers to Print to the Print Server Setup for Advanced Users Web Configuration Accessing the Web Configuration MenusWeb Configuration Web Interface HomeWeb Interface Login Screen Web Interface IP AddressWeb Interface Print Server Configuration Web Interface Upgrade FirmwareWeb Interface System Settings Changing Password Printing to Multiple Print Servers Section Printing to Multiple Print Servers Belkin Port Monitor Advanced Menu Opening the Belkin Port Monitor Advanced MenuBelkin Port Monitor Advanced Menu Click the Advanced tab Using the Print Server for FTP Printing Section Using the Print Server for FTP Printing Section Troubleshooting Cannot find Print ServerSection Troubleshooting Installation CD-ROM does not start Setup Utility Technical Support Europe 00 800 223 55 Australia 1800 666Information FCC StatementInformation ModificationsSection