RCA Line Level Inputs Stereo Left & Right

1.RCA Line Level Inputs (Stereo Left & Right)

For connection to a 2 channel/ stereo amplifier system. Connection should be provided by a pair of high-quality signal cables from the pre-out section of an amplifier. Note: - cable lengths should not exceed 10 metres to avoid interference from other electrical appliances.

2.RCA Line Level Outputs (Stereo Left & Right)

RCA line level outputs are provided in order to use other sub-woofers in conjunction with the GSW12 by ‘daisy chain’ type connection. The outputs are link out only connections and do not provide any form of filtering.

3.LFE Input (RCA Type)

This input is to be used when connecting the GSW12 to an AV amplifier/receiver. When using the LFE input, the crossover function in the menu/set-up is not used. This is due to the crossover function being controlled by the AV amplifier/ processor to which it is connected. Please refer to the crossover table on page 10 for further advice on which setting to use. Input between LFE and Stereo input (Inp) can be switched using the ‘LFE’ button on the remote control unit.

4.LFE Output/Link (RCA Type)

LFE output is provided in order to use other sub-woofers by ‘daisy chain’ type connection. The output is a link out only connection and does not provide any form of filtering.

5.12 Volt Trigger Input ~ Centre Pin = +12Vdc.

For external power control from AV amplifier/Receiver to the GSW12. Monitor Audio recommend using this function and a lead is supplied. This 12 volt signal is supplied by the AV amp/receiver and tells the GSW12 to turn on from standby mode. This allows a more accurately controlled method of the auto on/off function. It is also a lot more energy efficient. The display will change from a clock to a ‘3.5mm jack’ image (see key on page 1 of Set Up Guide for illustrations). The stand by function on the remote will not be operable when using the +12v trigger.

6.Mains Power Switch

Mains ‘rocker switch’ providing overall power off and on/auto. In the on/auto mode, the unit will turn on when an input signal is sensed, and will turn off after a user preset delay when the signal is removed (source turned off).

7.IEC Mains Power Connector/Fuse Location

The GSW12 is supplied with a two-pin mains input socket for connection to the mains supply. Use ONLY the appropriate IEC mains lead provided with the product. Also fitted is an external mains fuse. If a fuse blows during operation a spare fuse is provided within the fuse holder for replacement. If you wish to change the fuse, you can do this by removing the IEC mains lead and carefully levering out the original fuse from its holder below the IEC mains input socket (7a). If the fuse blows again it is advisable to seek help from an authorised service agent. DO NOT attempt to re-fit a further fuse as this could result in serious damage to the amplifier unit.

8.Recycling and Approval Certification

The approval identities will differ to that displayed depending on the country you are in.

9.Display

This LCD display provides full feedback of the amplifier settings. The default display will show the EQ settings, the output volume and graphic output display (constantly changing). When the enter button is pressed (on the remote), or the encoder pushed down, the ‘menu’ system is displayed. For full details of the menu system, please go to page 9.

EQ Setting (e.g. Impact)

Input (e.g. Stereo Input/LFE)

10. Push-Turn Control Button

Output Level

Graphic Output Display

This gives you full control (except EQ selection) of your GSW12. By default, you can adjust the volume (by turning the control button) and enter the menu system. Pushing the rotary encoder allows access of the menu system illustrated on page 9. For more detailed operation and set up please refer to page 10.

monitoraudio.co.uk