IrDA Printer | Maintenance |
3.Using a cotton swab dampened with alcohol, wipe the heating dots of the print head. Be careful not to touch the heating dots with your fingers.
4.Allow the alcohol to dry.
5.Reload the paper and close the paper cover.
Installing the Paper
Replace the paper when it runs out as indicated by the front panel green Power LED flashing.
1.Open the paper cover as previously described.
2.Remove the spent paper core.
3.Drop in a new paper roll so that it will rotate in the direction shown in Figure 2.
4.Insert edge of paper roll into slot in cover next to cutter; then close cover. Remove any slack by pulling out about ½ inch of paper from the printer.
Note: If there was unprinted data in memory when the paper ran out, and the printer was not shut OFF, then the printer will automatically go
Figure 2. Installing the Paper
Instruction | 9 |