IrDA Printer | Operation |
Operation
Precautions
To ensure the proper operation of the printer and prevent the possibility of voiding the warranty, be sure to observe the following precautions:
•Avoid dirty or dusty locations, or those with excessive heat or humidity
•Choose a stable level or solid wall on which to mount the printer
•Use only the supplied power adapter to charge the battery pack
•Ensure that the AC adapter will be plugged into the correct source of AC power
•Use only the supplied thermal paper or its replacement part
Self Test
The
1.Before running the self test, make sure there is sufficient paper to run the test (18" [46 cm]); the paper cover is closed; and that the printer is switched OFF.
2.Press and hold down the FEED pushbutton; then switch ON the printer to begin the test.
Note: The test can be aborted by switching OFF the printer.
3.The following typical information is printed, followed by the printer’s complete character set:
Version | : 1.1.6 |
Data bit | : 8 bit |
Parity | : None |
Baud rate | : 9600 bps |
Handshaking | : DTR |
Country | : U.S.A. |
Print mode | : Text (upright) |
Paper | : Normal paper |
Density | : 100% |
IrDA | : |
Buffer size | : 7000Byte |
Head volt | : 7.1V |
Head temp. | : 31°C |
Instruction | 5 |