Brady, Text Editing Notes | Brady 2200 specs

BRADY 12345

Text Editing Notes:

∙If you attempt to enter too many characters on a label line, the message “Reduce Type Size” will flash on the display. To allow more characters to fit on the line, press <Shift> + < ? > to decrease the font size.

∙To move within the text of a multi-line legend, use the arrow keys to move the cursor up, down, left, or right.

∙The font size, once set for a particular line, will remain constant for any new lines until changed by the user.

∙A change to the Rotation value will cause the following to occur:

◊all characters and lines on a label will be deleted

◊the cursor will move to the first character position on line 1.

◊the font will be set to the default size for the label

To ensure that text is not deleted, always set the rotation value before entering your legend.

∙You will know when you have attempted to enter more lines than will fit on a label when pressing the <Enter> key no longer moves the cursor down to another label line.

∙Any legend entered on the text editor will be saved when the unit is turned OFF. Just turn the unit back ON, and the legend will reappear on the display. This rule holds true only if the part number of the label roll loaded in the unit is not changed while the unit is turned OFF. If the TLS2200 System detects a label size change when turned ON, or if a different label size is loaded while the unit is ON, text on the display will be cleared, the default font size will be set, and the previously saved legend will be lost.

∙Pressing <Legend Clear> clears all characters from the currently displayed label line, keeping the font size unchanged.

∙Pressing <Shift> + <Legend Clear> clears all characters on the label keeping the font size for all label lines unchanged.

∙Pressing <Shift> + <Form Clear> deletes all characters and lines on the label, resets the font size to the default, and positions the cursor in the first character position on line 1.

∙Values set for Setup Menu options (Rotation, Horizontal and Vertical Justification, etc..) will remain unchanged when performing any of the following actions:

◊<Legend Clear>

◊<Shift> + <Legend Clear>

◊<Shift> + <Form Clear>

◊Turn the unit OFF

Values will change to default values however, if a new label roll with a different label size is loaded into the unit.

∙Text already entered on a line can be switched from “Text” to “Barcode” mode and vice versa. If the size of the bar code or text being switched to does not fit on the label, you