Brady 2200 user manual Barcode, Style

Peel Time:	Determines how long (in seconds) a label will remain in peel
	position before moving back to cut position. Ranges from 2 to 9
	seconds. Default = 5 sec. NOTE: Peel Time option is not
	supported for BradySleeve and PermaSleeve label parts.
Burn Time:	Determines the print density on the label. Setting ranges from -5
	(lightest) to + 5 (darkest). Default = 0
Term Repeat:	Adjusts the terminal block repeat value. Setting ranges from 5
	mm to 46 mm. < > > and < ? > keys increase/decrease value by
	0.125 mm increments (1 dot). <Shift> + < > > , <Shift> + < ? >
	increase/decrease value by 1mm increments (8 dots)
Clean Printer:	Performs printer cleaning routine (To be used with the cleaning
	card shipped with the unit.).

*Values range from -0.625 mm to +1.375 mm.

**Values range from -1 mm to +1 mm. The < > > and < ? > keys increase/decrease value by 0.125 mm increments (1 dot).

Barcode

The Barcode menu contains the following user options:

Bar Height:	Sets the height of the Code 39 bar code. Setting ranges from 1 to 15
	mm. Default = 1. Narrow bar width = 2 dots (.25 mm). Bar Code
	Ratio = 2 to 1
Human	Determines whether the bar code will be printed together with human
Readable:	readable text. Toggles between ON and OFF. Font Size = 2 (5 point)
	Default = OFF.

Style

The Style menu contains the following user options:

Rotation:	Sets the rotation in one of four orientations. 0E, 90E , 180E , 270E.
	Default orientation is dependent on the label roll loaded in the unit.
	NOTE: Rotation option is not supported for BradySleeve, PermaSleeve,
	and pre-printed label parts (defaults to 0E).
H Justify:	Sets the horizontal justification of the legend. Options are: Left, Center,
	Right. Default setting is determined by the label roll loaded in the unit.
V Justify:	Sets the vertical justification of the legend. Options are: Top, Center,
	Bottom. Default setting is determined by the label roll loaded in the unit.
Format:	Sets the Label Format. Options are: Component, Wire. The Component
	label format is designed to print all of the lines of a legend one time before
	advancing to the next marker. The Wire format is designed to automatically
	repeat the text of a legend down the length of a marker as many times as
	possible, considering the number of lines available in the marker. Default =
	Component.
	20